Canon JX200 User Manual page 65

CHECK DOCUMENT
Cause
The document is not set in the
Document Tray, or has jammed.
CHECK PAPER SIZE
Cause
The size of the paper in the multi-
purpose tray and that specified in the
PAPER SIZE setting are different.
CLEAR PAPER JAM
Cause
There is a paper jam.
DATA ERROR
Cause
An error has occurred and all one-
touch speed dialing, coded speed
dialing, and user data have been lost.
DOC. TOO LONG
Cause
The document is longer than
16.0 in. (400 mm).
ECM RX
Cause
The fax is receiving a document using
Error Correction Mode (ECM).
ECM TX
Cause
The fax is sending a document using
Error Correction Mode (ECM).
INK ABS NEAR FUL
Cause
The ink absorber is almost full.
NO INK
Cause
Ink has run out.
Set the document you are trying to send or copy (see page 16), or check for a
document jam and clear the jam if necessary (see page 53), and start again.
Load the correct paper size or change the <PAPER SIZE> setting (see
page 40).
Press [Stop].
Clear the paper jam (see page 53) and reload paper in the Multi-Purpose Tray.
Press [Stop].
Press [Start/Copy], then re-register the data (see page 7).
Use a copier to make a reduced copy of the document and then send the copy.
ECM receptions may take longer than normal receptions. Turn off ECM if you
need to receive quickly, or if you know your local lines are in good condition (see
<ECM RX> on page 39).
ECM transmissions may take longer than normal transmissions. Turn off ECM if
you need to transmit quickly, or if you know your local lines are in good condition
(see <ECM TX> on page 39).
Printing will no longer be possible once the ink absorber is full. Contact the
service center immediately. Press [Stop] to continue printing.
Replace the FINE Cartridge (see page 43).
Action
Action
Action
Action
Action
Action
Action
Action
Action
Troubleshooting 63