Canon JX200 User Manual page 66

Canon jx200: users guide
Hide thumbs Also See for JX200:
Table of Contents

Advertisement

INK VOL UNKNOWN
Cause
The remaining level of the ink cannot
be correctly detected.
MEMORY FULL
Cause
The fax's memory is full because it has
received too many documents, or a
very long or detailed document.
The fax's memory is full because you
either tried to send or copy too many
pages at once, or you tried to send or
copy a very long or detailed document,
using memory sending.
NO TEL #
Cause
The one-touch speed dialing button or
coded speed dialing code you entered
has not been registered.
REC'D IN MEMORY
Cause
The fax received the document in
memory because paper or ink ran out,
a paper jam occurred, or the incorrect
FINE Cartridge was installed.
RECOMEND NEW CRT
Cause
Ink is low.
REMOVE DOCUMENT
Cause
The document is set while printing.
SET DOCUMENT IN CORRECT POSITION
Cause
The document cannot be correctly
detected or the document is too small.
TX/RX CANCELLED
Cause
You pressed [Stop] to cancel the
transmission.
64
Troubleshooting
A FINE Cartridge that was once empty is installed. Replace the FINE Cartridge
(see page 43).
Print and delete any documents stored in memory (see page 34).
Then start again.
Free up space in the fax's memory by printing or deleting any documents in
memory you no longer need (see page 34).
If multiple pages are loaded, separate the pages into smaller stacks. If not, try
sending the document by direct sending (see page 19).
Register the one-touch speed dialing button or coded speed dialing code (see
page 13).
Load paper in the Multi-Purpose Tray (see the Easy Setup Instructions), replace
the FINE Cartridge (see page 43) or clear the paper jam (see page 53).
Print any documents stored in memory (see page 34).
Replace the FINE Cartridge (see page 43).
Remove the document. Press [Stop] and try printing again.
Make sure the document meets the requirements and is correctly loaded. If
necessary, reload the document and press [Start/Copy]. See "Document
Requirements" on page 15 and "Loading Documents and Paper" on page 16.
If required, try sending again.
Action
Action
Action
Action
Action
Action
Action
Action

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fax-jx 201Fax-jx 200Fax-jx201

Table of Contents