Installing The Operation Panel; Connecting The Ground Wire - Brother LK3-B448E Instruction Manual

3-16. Installing the operation panel

The operation panel can be installed to either the top or bottom of the work table.
w
q
1. Install the operation panel presser plate q to the top of the button feeder cover with the two screws w.
2. Insert the panel e into the operation panel presser plate q, and then secure it with the two screws r.
3. Insert the connector cord t into the control box through the hole at the side of the box. Refer to "3-13. Connecting
the cords" for details on connecting the cord.

3-17. Connecting the ground wire

Be sure to connect the ground. If the ground connection is not secure, you run the risk of receiving a
serious electric shock, and problems with correct operation may also occur.
r
Red
White
Black
Yellow/Green ....... Connect to ground
LK3-B448E MARK
e
CAUTION
Connect to the power switch. However, the
black wire is insulated to the inside of the
box and is not used.
II /BA-16
3. Installation
17