Before First Use; The Water Softener (Colourcare) - Electrolux EW9F2119RA User Manual

12 www.electrolux.com
1
ø16
Connect the drain hose to the spigot and
tighten it with a clamp. Make sure that
the drain hose makes a loop to prevent
particles going into the appliance from
the sink.
6. Position the hose directly to a built-in
drain pipe in the room wall and tighten it
with a clamp.
5.3 Electrical connection
At the end of installation you can connect
the mains plug to the mains socket.

6. BEFORE FIRST USE

1. Make sure that the electrical power is
available and the water tap is open.
2. Make sure that there is salt in the
compartment marked by
the proper water hardness level.
Refer to "How to set the water
hardness level".
3. Pour 2 litres of water into the
detergent compartment marked by
.

7. THE WATER SOFTENER (COLOURCARE)

7.1 Introduction
The water contains harsh minerals. The
higher the content of these minerals the
harder the water is.
2
W011
Salt
The rating plate and the 'Technical Data'
chapter indicate the necessary electrical
ratings. Make sure that they are
compatible with the mains power supply.
Check that your domestic electrical
installation can take the maximum load
required, also taking into account any
other appliances in use.
Connect the appliance to an earthed
socket.
The power supply cable must be easily
accessible after installing the appliance.
For any electrical work required to install
this appliance, contact our Authorised
Service Centre.
The manufacturer does not accept any
responsibility for damage or injury
through failure to comply with the above
safety precaution.
This action activates the drain system.
4. Pour a small quantity of detergent
into the compartment marked by
5. Set and start a programme for cotton
and set
at the highest temperature without
any laundry in the drum.
This removes all possible dirt from the
drum and the tub.
Hard water can reduce the effectiveness
of the detergent, reduce the softness of
fabrics and contribute towards shrinkage
and colour fading.
.