E13: Water Leak In Tub Or In Pressure Sensor - Electrolux EFLS617SIW Technical & Service Manual

E13: Water Leak in Tub or in Pressure Sensor

E13
Maximum overall water fill time exceeded (sum of all water fills between one
drain phase and the next to avoid exceeding the maximum volume).
Checks to perform:
Check for leakage in Washer. Is the Washer leaking
Is drain hose 8" or less into stand pipe?
Check if the air tube is connected properly without
kinking and leaking? (Disconnect the tubes, and blow
into them to make sure the system is unobstructed).
(See Fig. 1)
Is the frequency of Pressure Sensor between 44.5 Hz
and 45 Hz? (Measure it on the Pressure Sensor wiring
connector at Main Control Board when machine is
powered with empty tub (No water).) (See Fig. 2)
Replace the Main Control Board, and repeat the
diagnostic cycle to check for any further errors.
Troubleshooting Based on Error Codes
water?
N
O
Y
E
S
Y
E
S
Y
E
S
WARNING
Check that all the connectors are correctly
inserted.
Repair water leak, and repeat the diagnostic
YES
cycle to check for any further errors.
NO
Replace / Repair the air tube, and repeat the
NO
diagnostic cycle to check for any further errors.
Replace Pressure Sensor, and repeat the
NO
diagnostic cycle to check for any further errors.
37
E13
Adjust it.