Input Source Selection (Component, Rgb Scart 21-Pin) - Canon LV-5210 Owner's Manual

Input Source Selection (Component, RGB Scart 21-Pin)

Direct Operation
Choose Computer 2 by pressing the INPUT button on the top control
or press the COMPUTER button on the remote control unit.
Before using these buttons, correct input source should be selected
through menu operation as described below.
Menu Operation
1 Press the MENU button and the On-Screen Menu will appear.
Press the Point Left/Right button to move the red frame pointer
to the Input Menu icon.
2 Press the Point Down button to move the red arrow pointer to
either Computer 1 or Computer 2 (Only the Computer 1 is
displayed when Monitor out is selected in the Setting Menu.),
and then press the SET button. The Source Select Menu will
appear.
3 Move the pointer to the correct input source and then press the
SET button.
When the input source is coming from video
Component
equipment connected to the RGB IN-2/
COMPONENT IN/ RGB OUT terminal with a
Component-VGA Cable, select Component.
When the input source is coming from video
RGB (Scart)
equipment connected to the RGB IN-2/
COMPONENT IN/ RGB OUT terminal with a Scart-
VGA Cable, select RGB (Scart).
NOTE
G
Component-VGA Cable and Scart-VGA Cable are optionally supplied. See
page 53 for order.
INPUT button
Computer 1
✽
Computer 2
Video
COMPUTER button
Computer 1
✽
Computer 2
✽
Computer 2 is not displayed when the RGB IN-2/ COM-
PONETN IN/ RGB OUT terminal is used as Monitor out.
Input Menu
Input Menu icon
Move the pointer (red arrow)
to Computer 2 and press the
SET button.
Computer
2
Source Select Menu
Move the pointer to
Component or RGB (Scart)
and press the SET button.
Video Input
33