Video Input; Input Source Selection (Video, S-Video) - Canon LV-5210 Owner's Manual

Video Input

Input Source Selection (Video, S-Video)

Direct Operation
Choose Video by pressing the INPUT button on the top control or the
VIDEO button on the remote control unit.
Before using these buttons, correct input source should be selected
through menu operation as described below.
Menu Operation
1 Press the MENU button and the On-Screen Menu will appear.
Press the Point Left/Right button to move the red frame pointer
to the Input Menu icon.
2 Press the Point Down button to move the red arrow pointer to
Video and then press the SET button. The Source Select Menu
will appear.
3 Move the pointer to the source that you want to select and then
press the SET button.
When selecting Auto, the projector automatically detects
Auto
incoming video signal, and adjusts itself to optimize its
performance. The projector selects connection in the
following order:
1st S-Video
2nd Video
The S-VIDEO IN jack has priority over the VIDEO IN jack
under the condition of connecting both the S-VIDEO IN
jack and the VIDEO IN jack.
When video input signal is connected to the VIDEO IN
Video
jack, select Video.
When video input signal is connected to the S-VIDEO IN
S-Video
jack, select S-Video.
NOTE
G
See "Computer Input" on page 24 for a signal compatible with HDCP.
32
INPUT button
Video
Computer 1
✽
Computer 2
VIDEO button
Video
✽
When Monitor out is selected at the Terminal item
in the Setting Menu, Computer 2 is not displayed.
Input Menu
VIDEO
Source Select Menu (VIDEO)
Move the pointer to the source that you want to select
and press the SET button.
✽
When Monitor out is selected at the Terminal item in the
Setting Menu, Computer 2 is not displayed.
Move the pointer to
Video and press the
SET button.