Terminal - Canon LV-5210 Owner's Manual

Part Names and Functions

Terminal

Do not press this button. This button is used for optional
accessories.
q
DVI-I / RGB IN-1
Connect computer output (Digital/Analog DVI-I type) or Multi
Card Imager (optional) to this terminal. (p17)
w
SERVICE PORT
This jack is used to service this projector.
e
AUDIO IN
Connect the audio output from video equipment connected to
r or i to this jack. (When the audio output is monaural,
connect it to L (MONO) jack.) (p18)
r
VIDEO IN
Connect the composite video output from video equipment to
VIDEO IN jack. (p18)
t
USB (Series B)
When operating the connected computer with the remote
control unit, connect USB port of your computer to this
connector with a USB cable.
* A built-in micro processor which controls this unit may rarely malfunction
and need to be reset. This can be done by pressing the RESET button
with a pen, which will shut down and restart the unit. Do not use the
RESET function excessively.
10
q w
DVI-I/
AUDIO
RGB IN-1
R
*
SERVICE PORT
RESET
MCI RGB IN-2/
COMPONENT IN/
RGB OUT
(p17)
e r t y
VIDEO IN
IN L
S-VIDEO IN
COMPUTER
AUDIO IN
AUDIO OUT
u i o
y
COMPUTER AUDIO IN
Connect the audio output (stereo) from a computer or video
equipment connected to q or u to this jack. (p 17, 18)
u
RGB IN-2 /COMPONENT IN / RGB OUT
This terminal is switchable and can be used as computer input ,
component input, RGB Scart 21-Pin Video input, or monitor
output. Set the terminal up as either Computer input or
Monitor output properly before using this terminal. An optional
cable is required when using this terminal as component input
or RGB Scart 21-Pin Video input. (p17,18)
(This terminal outputs analog signal from DVI-I IN / RGB IN-1
terminal only when using as Monitor out.)
i
S-VIDEO IN
Connect the S-VIDEO output from video equipment to this jack.
(p18)
o
AUDIO OUT
Connect an external audio amplifier to this jack. (p17, 18)
This terminal outputs sound from AUDIO IN terminal (
e y
or ).