Safety - Kessel Aqualift S 100 tronic Manual

2

Safety

2.1 Personnel - qualification
The relevant operational safety regulations and the hazardous substances ordinance or national equivalents apply for the
operation of the system.
The operator of the system must:
prepare a risk assessment
identify and demarcate corresponding hazard zones
carry out safety training
secure the system against unauthorised use.
Person
1)
Operating company
Technical expert, (familiar with,
understands operating instructions)
Technical specialist, (technical
worker, per installation instruc-
tions and execution standards)
Electrical specialist VDE 0105
(per regulations for electrical
safety, or per national equivalents)
1) Operation and assembly work may only be carried out by persons who are 18 years of age.
2.2 General safety notes
The accident prevention regulations, the applicable standards and directives as well as the regulations from the local energy
and supply companies must be observed during the installation, operation, maintenance and repair of the system.
NOTICE
Disconnect system from energy sources!
Ensure that the electrical components are disconnected from the electrical power supply during the work.
WARNING
Live parts!
Heed the following points when working on electrical cables and connections:
The national safety regulations apply for all electrical work on the system.
The system must be supplied through a residual current protection device (RCD) with residual current of not
more than 30mA.
The float switch unit are live and must not be opened.
Make sure that the electric cables as well as all other electrical installation components are in a faultless condition. In case of
damage, the system may on no account be put into operation or must be stopped immediately.
WARNING
Danger due to overvoltage!
Operate the system only in buildings in which an overvoltage protection system (e.g. surge arrestor, type 2 per
VDE regulations) is installed. Interference voltage can seriously damage electrical components and lead to sys-
tem failure.
CAUTION
Hot surfaces!
Pumps can become very hot during operation.
Wear protective gloves or allow the pump to cool.
WARNING
Transport risk / system's own weight!
Check the weight of the system / system components (see "Technical data").
Pay attention to correct lifting and ergonomic factors.
016-228_01
Approved activities on KESSEL systems
Visual check, inspec-
tion, change of battery
Emptying, cleaning
(inside), functional
check, configuration
of the control unit
Installation, replace-
ment, maintenance
of components,
commissioning
Work on electri-
cal installation
25 / 132