Würth AL30-CV-IND-LI Manual page 11

Technical file (2006/42/EC) at:
Adolf Würth GmbH & Co. KG, Abt. PCM
Reinhold-Würth-Straße 12–17
74653 Künzelsau
GERMANY
www.wuerth.de
Marcel Strobel
General Manager
Künzelsau: 15.08.2015
Starting Operation
 Observe the mains voltage! The voltage of the
power supply must correspond with the data given on the
nameplate of the battery charger. Battery chargers
marked with 230 V can also be operated with 220 V.
Charging Procedure
The charging process begins as soon as the mains plug of the
charger is plugged into the socket outlet and the inductive bat-
tery 1 or the power tool with battery 1 (with base of the bat-
tery) is placed onto the charging platform 5.
The charging process only begins when the battery capacity
is less than 85 – 90 %. This prolongs the life of the battery.
Due to the intelligent charging method, the charging condition
of the battery is automatically detected and the battery is
charged with the optimum charging current, depending on
battery temperature and voltage.
This gives longer life to the battery and always leaves it fully
charged when kept in the charger for storage.
Using the Charger with the Holder
Removing the Charger (see figure A)
 Do not pull on the cable to remove the charger
from the holder 6. Damaged cables increase the risk
of an electric shock.
Slide the charger out of the holder 6.
Mounting the Holder 6 (see figure B)
Mount the holder on a surface using four screws.
Inserting the Charger (see figure C)
Slide the charger into the holder 6.
Dr.-Ing. Siegfried Beichter
General Manager
Inserting the Battery (see figure D)
Slide the battery or the power tool with battery 1 into the
guide rails at the sides.
Meaning of the Indication Elements
Continuous Light Standby Indicator
(green) 2
The continuous light of the green standby indi-
cator 2 shows that the mains plug has been
plugged into the socket outlet and the charger is
ready for use.
Flashing Charge Status Indicator 3
The fast charging process is indicated by the
flashing of the respective green LED of
the charge status indicator 3. When the
respective share of the battery is charged,
the green flashing light changes to a green continuous
light.
The battery can be removed at any time and used. When all
five LEDs indicate a green continuous light, the battery is fully
charged.
Continuous Light Error Indicator (red) 4
The continuous light of the red error indicator
4 shows that the temperature of the battery is out-
side of the permitted charging temperature range,
see section "Tool Specifications". As soon as the
permitted temperature range is reached, the charger automat-
ically switches to fast charging.
Flashing Error Indicator (red) 4
The flashing light of the red error indicator 4
signals a different fault of the charger, see section
"Troubleshooting – Causes and Corrective Meas-
ures".
Troubleshooting – Causes and
Corrective Measures
Cause
Red error indicator 4 flashes
No charging procedure possible
The battery is not positioned
(correctly)
Corrective Measure
Position the battery centrally
with the battery base on the
charging platform 5
11