Husqvarna K7000 Ring Workshop Manual page 29

5
5 6
8
MOTOR
7
7
5
6
7
5. Separate the 2 connectors for the motor.
6. Remove the hose clip and pull off the hose that runs from the
water connection to the motor.
7. Remove the hose clip and pull off the hose that runs from the
motor to the water valve.
Pull off the hose that runs from the water valve to the water disc.
8. Turn the machine. The motor is secured to the cutting arm with
four screws. Remove the screws (M5x12, 7–8 Nm).
The motor can then be lifted out.
Do not dismantle the motor!
A defective motor cannot be reconditioned without specialist
expertise and special tools. The entire motor must be replaced if it
is defective.
14
29