Special Features; Repeating An Image Over The Paper - Canon MultiPASS F30 Reference Manual

Special Features

The machine has the following SPECIAL COPY features. These features allow you to create special copies
easily by selecting from menus.
– IMAGE REPEAT: Repeating an image over the paper
– MIRROR IMAGE: Creating a mirror image
– ENTIRE IMAGE: Shrinking an image to fit onto the paper
These features are only available in Copy Mode.
• Please note that you cannot set the SPECIAL COPY features during copying.
• After the machine finishes copying, the current setting will remain. However, if you press Stop/Reset
NOTE
or if no button is pressed for one minute, the machine will reset to the default setting.

Repeating an Image over the Paper

Use IMAGE REPEAT to print multiple copies of an image on a single sheet. You can select the number of times
you want to repeat the original image.
I Scanned Area of a Document
The scanned area of a document differs between documents placed on the platen glass and documents loaded into
the ADF.
• The examples below show the scanned areas when copying a document on the same size of paper repeated 2 ×
2 times.
Platen Glass (face down)
SCANNED AREA
The scanned area of a document depends on the paper size to be printed on and the number of times which it is repeated.
• The examples below show the scanned areas when copying a document placed on the platen glass onto the
same size of paper.
2X2
SCANNED AREA
• The scanned area of a document also depends on the enlargement/reduction ratio.
NOTE
ADF (face up)
SCANNED AREA
3X3
SCANNED AREA
4
4-5