Table of Contents
Advertisement
Available languages
Available languages
2. Rinse the air tubing thoroughly in water.
3. Allow to dry out of direct sunlight and/or heat.
Checking
You should regularly check the air tubing for any damage. If there
are any holes, tears, or cracks, you should replace it.
Reassembly
When the air tubing is dry, you can reconnect it to the device.
1. Connect the air tubing firmly to the air outlet located on the
rear of the device.
2. Connect the free end of the air tubing firmly onto the
assembled mask.
Troubleshooting
If you have any problems, refer to the troubleshooting section of
your device user guide or www.resmed.com.
For any serious incidents that occur in relation to this device,
these should be reported to ResMed and the competent authority
in your country.
Technical specifications
Environmental conditions
Operating temperature:
Operating humidity:
Operating altitude:
Storage and transport
temperature:
Storage and transport humidity:
Design life
Air tubing:
Air tubing dimensions
Air tubing
ClimateLineAir 11
Operating ranges
Maximum recommended
pressure:
Temperature range:
Temperature cut-out:
4
+41°F to +95°F (+5°C to +35°C)
Note: The air flow for breathing
produced by this therapy device can be
higher than the temperature of the room.
Under extreme ambient temperature
conditions (104ºF/40ºC) the device
remains safe.
10 to 95% relative humidity, non-
condensing
Sea level to 9,870' (3,010 m); air pressure
range 700 hPa to 1060 hPa
-13°F to +158°F (-25°C to +70°C)
5 to 95% relative humidity, non-
condensing
6 months
Material
Flexible
plastic and
electrical
components
30 cm H
O (30 hPa)
2
+60°F to +86°F (+16°C to +30°C)
≤ 106°F (≤ 41°C)
Length
Inner
diameter
6'6" (2.0m) 0.6" (15
mm)
Advertisement
Table of Contents
