Pace MBT 250 Operation & Maintenance Instructions Manual page 11

DISPLAY DISPLAY
DISPLAY DISPLAY
DESCRIPTION DESCRIPTION DESCRIPTION DESCRIPTION
MESSAGE MESSAGE
MESSAGE MESSAGE
Indicates system is ready to process Digital Readout accuracy
C-1 OR C-2 calibration for a particular channel using the appropriate
calibration module.
CAL Indicates that system is in the Calibration Mode.
Input to control circuitry unstable. Indicates that no calibration
E-5 module is connected to the channel being calibrated or the
incorrect module has been inserted.
Loose connection. Calibration input is out of range. Normally
E-6
occurs if incorrect calibration module is inserted.
H-X Indicates the Current Channel is ready to accept new Upper
(X = 1 thru 9) Temperature Limit setpoint X (X times 100°F).
L-X Indicates the Current Channel is ready to accept new Lower
(X = 1 thru 9) Temperature Limit setpoint X (X times 100°F).
Setpoint for this channel is below Lower Temperature Limit
OFF
setpoint.
Indicates that the Automatic Temperature Setback (and Power
S--
Down) feature is disabled (turned off).
Indicates that the Automatic Temperature Setback (and Power
Down) feature is enabled (turned on) and will set each channels'
S-X
Set Tip Temperature back after X times 10 minutes of handpiece
inactivity (non-use).
--- Indicates that the system circuitry is proceeding with calibration
(flashing) using the proper calibration module (C-1 or C-2).
11