Tannoy QFLEX 16LS-WP Quick Start Manual page 10

Digitally steerable powered column array loudspeaker with 16 independently controlled drivers, integrated dsp and beamengine gui control for life safety installation applications (weather protected)

Hide thumbs

Table of Contents

Available languages

QFLEX 16LS-WP

Assembly

Place each module in its respective position on the assembly area keeping them slightly spaced apart. All electronic components are housed in the master module of a

QFlex 16LS. Connect the multipin connectors as shown.

Align the two columns together as shown below.

Having the hinge points on either side of the QFlex column allow the loudspeaker to be rotated at 90 degrees to the mounting structure allowing easy access to

the input connector panel.

The installer must ensure that the mounting surface is capable of safely and securely supporting the loudspeaker. Seek help from architects, structural engineers or

other specialists if in any doubt.

Attach the joining plates in the three stages as shown. Only one wall

bracket is required to mount the two modules. For flexibility the wall

bracket can be mounted to either the top or the bottom column. The wall

bracket can be hinged on the left or right pivot points. 3mm Allen grub

screws allow the QFlex to be locked at the desired horizontal angle.

Mounting

QFLEX 16LS-WP

For mounting instructions and schematics, please refer directly to QFlex Operations Manual - available at Tannoypro.com.

209.0 [8.2]

2525.2 [99.4]

64.6 [2.5]