Table of Contents
Advertisement
8
can be added by selecting 'More'. Hide the keypad and select 'Start
Recording'
5.
When ready, select 'Start' to begin the scanning process. The Laser
Housing unit will begin to rotate and after a short period
measurement data will begin to appear on the display. The scan is
automatically broken up into sections. Scanned data is displayed on
the Control Unit after each section has been scanned. By clicking
'Cancel' it is possible to stop the scan at any time; the scan will stop
after it has completed the current section
6.
When the scan is complete, the laser will switch off and the Laser
Housing will rotate back to its Zero position
7.
The profile can now be saved or re-measured – to insert additional
points click 'Single Point'. Position the laser (see Section 4.4) and
click 'Measure'. See below for more information on this step
Single Point
1. Select 'Start Recording' from the 'Options' screen (Figure 1)
2. Select 'Single Point' from the next menu (Figure 6)
3. Control the laser as described in section
4. Click 'Measure' – select 'Save Point' to confirm the measurement – a note
can now be added against this point
5. After adding a note, hide the keypad and click 'Save Point' again.
Note – it is not possible to send commands, other than 'Cancel', from the
Control Unit when the Laser Housing is rotating. Ensure that the Laser
Housing is stationary before clicking any other buttons or closing a
window.
4650-1 Issue 04
Advertisement
Table of Contents
