Bluetooth Connection - Abtus ABT4650 RouteScan Instruction Manual

Hide thumbs Also See for ABT4650 RouteScan:
Table of Contents

Advertisement

4
It is a Class II laser product in accordance with:
1) IEC60825-1 (2001) "Radiation safety of laser products"
2) EN60825-1 (2001) "Radiation safety of laser products"
3) FDA 21 CFR 1040.10 and 1040.11 (US department of health and human
service, Code of federal Regulations)
Laser Class II products:
Do not stare into the laser beam or direct it towards other people unnecessarily.
Eye protection is normally afforded by aversion responses including the blink
reflex.
CAUTION
Looking into the laser beam may be hazardous to the eyes.
Laser may turn on without warning.
Do not allow water droplets to fall on the lens of the laser housing as this may
compromise accuracy. If water does drop on the lens, carefully blot away using
the lens tissue provided. Follow the instructions in Section 7.1 to clean the lens if
necessary.
Please review Section 9.1 prior to using your ABT4650 for the first time.
Assembly
4.2
Upon receipt of your ABT4650 no assembly is required.

Bluetooth Connection

4.3
Before recording can start, a Bluetooth connection must be made between the
Control Unit and the ABT4650 – imagine this step is like plugging in the cable:
1. Turn on the Control Unit (Please refer to manufacturers own operating
manual for details of operation as Control Unit models may vary) – wait
until the Windows operating system has fully loaded
2. Load the Abtus Gauge Interface software from the Start Menu (as shown
in Figure 1) – the software launches directly to the 'Connection' screen
4650-1 Issue 04

Advertisement

Table of Contents
loading

Table of Contents