Table of Contents
Advertisement
ticking the 'Absolute' tick box
•
Tick the 'Target Pole' tick box to measure to a point using the target
2
pole
Note – it is not possible to send commands from the Control Unit when the
Laser Housing is rotating. Ensure that the Laser Housing is stationary
before clicking any buttons or closing a window.
Recording Data
4.5
Profile:
1.
The parameters used when recording a profile are set in the 'Settings'
Menu – see Section 5.1
2.
Select 'Start Recording' from the 'Options' screen (Figure 1)
3.
Select 'Profile' from the next menu (Figure 6) – note that it is also
possible to add a series of Single Point measurements to a profile
recording
4.
In the 'Session Details' screen, enter a file name. A start description
2
See section 6.0 for more details.
Figure 5
Figure 6
4650-1 Issue 04
7
Advertisement
Table of Contents
