Table of Contents
Advertisement
Symptom
If a DHCP/BOOTP server or a
RARP server resides on the
network, the IP address is
automatically issued by the
server. In this case, the IP
address that was manually set
for the PS-9000 may have
been overwritten by the
The print job is
server.
not printed.
If the PS-9000 and the
computer are not in the same
segment, a subnet mask and
gateway address must be set
for the PS-9000.
Depending on the operating
Dial-up starts
system being used, the
when printing
automatic dial-up setting may
is performed.
have been specified.
If the unit stopped operating
because of a tape width error
An error
or no more tape in the cassette
occurs during
during another user's print job,
printing.
printing is not possible until
the error is cancelled.
LPR printing is
With some of the P-touch
not available
machines, LPR printing is not
available.
with PS-9000.
If PT-9500PC is connected to
The tape width
the PS-9000, the tape width
cannot be
detection function of P-touch
detected by
Editor 4 and Quick Editor does
not operate. (There is no tape
P-touch Editor 4
width detection function with
or Quick Editor.
PT-9200DX.)
Can the PS-9000
be initialized
(reset to its fac-
tory default set-
tings)?
Cause
Create a local environment where the server does
not exist and issue the IP address to the PS-9000. At
the same time, make sure that "Obtain an IP address
automatically" in the TCP/IP setting is not marked.
Use the Brother PS-9000 Utility to check whether
the subnet mask and gateway address are correct.
Check the printer port name of the PS-9000. The
port name is indicated by "(PTLAN xxxxxx: P-touch
TCP Port)" after the assigned port name.
When using PS-9000, cancel the setting for
automatic dial-up or, if the automatic dial-up setting
cannot be cancelled, click [Cancel] in the dialup
dialog box to begin printing.
After the other user's print job is finished, try printing
again. Otherwise, use the Web browser to restart
the PS-9000, and then try printing again.
With the PT-9200DX, install the printing software
for the PS-9000 onto each client, and use it instead
of using LPR printing.
Manually specify the tape width.
PS-9000 can be initialized (reset to its factory default
settings) by using the Brother PS-9000 Utility.
Select PS-9000 in the PS-9000 setting dialog box of
the Brother PS-9000 Utility, and then click
[Initialize]. Otherwise, the PS-9000 can be
initialized by pressing the push button. For further
information on how to initialize PS-9000 by pressing
the push button, refer to "Parts and Functions" in
chapter 1, "About PS-9000".
Remedy
29
Advertisement
Table of Contents
