Table of Contents
Advertisement
Back
Network Port
(10BASE-T/100BASE-TX)
■ Network Port (10BASE-T/100BASE-TX)
Connection for the network cable.
*In 100BASE-TX environment, use category
5.
■ USB Port
Connection for the USB cable.
■ Power Connector
Connection for the AC adapter.
■ Factory Default Settings
Make sure that the AC adapter is not connected to the PS-9000.
1
While pressing the push button, connect the AC adapter to the PS-9000. The STATUS LED
2
(orange) will blink once when the connection is made.
Continue to press the push button for two seconds. The STATUS LED will blink again when the
3
settings are successfully reset to the factory default settings. Release the push button.
Caution
●
Do not turn off the PS-9000 while it is being initialized to the factory default settings.
●
When the PS-9000 is turned on again after being initialized to the factory default settings, do not
press the push button.
●
The PS-9000 can be initialized to its factory default settings from the Brother PS-9000 Utility.
8
Power Connector
USB Port
Right side
■ Push Button
Press this button to reset PS-9000 to its
factory default settings.
Push Button
Advertisement
Table of Contents
