Ps-9000 Settings - Brother PS-9000 User Manual

PS-9000 Settings

Below are the settings for PS-9000.
General
CD-ROM
Setup
TCP/IP
CD-ROM
Setup
Receive IP
address
automatically
IP Address
Name
Web page
LAN Interface AUTO
Name
Web page
DHCP/BOOTP
RARP
IP Address
Factory
Default
Set up network type. Normally use in
AUTO. If the LINK LED on the hub
does not light up after the PS-9000 is
turned on, select the appropriate
network type for the hub.
Factory
Default
Enables or disables DHCP/BOOTP.
These are protocols where the IP
address is acquired from the
DHCP/BOOTP server during start up.
In order for DHCP/BOOTP to specify
the IP address of the PS-9000, a
ENABLE DHCP/BOOTP server must exist
within the subnetwork and be
properly set up. The PS-9000 will
automatically acknowledge DHCP
and BOOTP, and use as its own
address the IP address that it
previously received as a reply.
Enables or disables RARP. RARP is a
protocol where the IP address is
acquired from the RARP server during
ENABLE start up. In order for DHCP/BOOTP to
specify the IP address of the PS-9000,
a RARP server must exist within the
subnetwork and be properly set up.
Sets up the IP address of the PS-9000.
The value must be configured in the
0.0.0.0 format of four series of numbers
separated by decimal points, such as
"xxx.xxx.xxx.xxx".
Explanation
Explanation
41