Canon PIXMA MX340 Simplified Service Manual page 12

Hide thumbs Also See for PIXMA MX340:

Getting started (111 pages)

Network setup manual (26 pages)

Installation manual (17 pages)

Table of Contents

Error

TX /

code

##780 TX

After transmitting EOR-EOM in ECM transmission,

no significant signal has been received, and

re-transmission of the procedure signal has been

attempted the number of specified times but failed.

##782 TX

After transmitting EOR-EOM in ECM transmission,

DCN has been received.

##783 TX

After transmitting EOR-EOM in ECM transmission,

re-transmission of the procedure signal has been

attempted the number of specified times but failed,

or T5 time-over (60 sec.) has occurred.

##784 TX

After transmitting EOR-EOM in ECM transmission,

ERR has been received.

##785 TX

After transmitting EOR-EOP in ECM transmission,

no significant signal has been received, and

re-transmission of the procedure signal has been

attempted the number of specified times but failed.

##787 TX

After transmitting EOR-EOP in ECM transmission,

DCN has been received.

##788 TX

After transmitting EOR-EOP in ECM transmission,

re-transmission of the procedure signal has been

attempted the number of specified times but failed,

or T5 time-over (60 sec.) has occurred.

##789 TX

After transmitting EOR-EOP in ECM transmission,

ERR has been received.

##790 RX

After receiving EOR-EOP in ECM reception, ERR

has been transmitted.

##791 TX /

During the ECM mode procedure, a signal other

than a significant one has been received.

##792 RX

In ECM reception, PPS-NULL between partial

pages has not been detected.

##793 RX

During high-speed signal reception in ECM, no

effective frame has been detected, and a time-over

has occurred.

Meaning

(11/37)

Solution

(parts that are likely to be faulty)

- Try a higher transmission level.