Fax Errors - Canon PIXMA MX340 Simplified Service Manual

1-3. FAX Errors

For errors other than those listed below, please refer to the "G3 / G4 Facsimile Error Code List (Rev.
2)" (HY8-23A0-020 in English).
< User error codes >
Error TX /
code RX
#001 TX Document jam
#003 TX / Document is too long, or page time-over
RX
#005 TX / Initial identification (T0 / T1) time-over
RX
#012 TX No recording paper at the receiving machine
#017 TX Redial time-over, but no DT detected
#018 TX Auto dialing transmission error, or redial time-over
#022 TX Call failed (no dial registration)
#037 RX Memory overflow at reception of an image
#046 RX Direct mail rejection (rejection of mail reception)
#059 TX Dialed number not matches the CSI of the
connected machine
#085 TX No color fax function supported in the receiving
machine
#099 TX / Transmission terminated mid-way by pressing the
RX Stop button
#995 TX / During TX (sending):
RX Memory transmission reservation cancelled
During RX (receiving):
Image data received in the memory cleared
< Service error codes >
Error TX /
code RX
##100 TX Re-transmission of the procedure signal has been
attempted the specified number of times, but failed.
##101 TX / Sender's modem speed does not match the
RX receiving machine.
##102 TX Fallback is not available.
##103 RX EOL has not been detected for 5 seconds (or 15
seconds in CBT).
##104 TX RTN or PIN has been received.
##106 RX The procedure signal has been expected for 6
seconds, but not received.
##107 RX Fallback is not available at the sending machine.
Meaning
Meaning
(7/37)
Solution
(parts that are likely to be faulty)
- Document upper guide
- Document upper guide
- Check the telephone line type settings
(rotary pulse / touch tone).
- Check the telephone line type settings
(rotary pulse / touch tone).
- Register a dial number.
- Delete unnecessary image data from
the memory.
- Register the dial number of the calling
machine.
- Register the dial number (CSI)
properly on the receiving machine.
- Send a fax in the B&W mode.
Solution
(parts that are likely to be faulty)
- Try a higher transmission level.
- Try a higher transmission level.
- Increase the transmission level of the
sending machine.
- Try a higher transmission level.
- Increase the transmission level of the
sending machine.
- Increase the transmission level of the
sending machine.