Appendix A: Technical Specifications - Oxford Instruments ANDOR Newton CCD Hardware Manual

Newton

APPENDIX A: TECHNICAL SPECIFICATIONS

(Refer to specifications sheet for model variations and performance specifications)
General Specifications
Dimensions mm [inches]
Environmental Specifications
Operating Temperature
Storage Temperature
Operating Relative Humidity
Overvoltage Category
Cooling vent clearance
Cable clearance (at rear of camera)
Power Requirements
Power Consumption
Model Specific Information
Refer to the specification sheet for further technical and performance information required model:
• Newton CCD
• Newton EMCCD
• Newton SO
• Newton SY
Version 1.4 rev 13 Oct 2017
Weight
W x H x D
Usage
Ingress Protection
CAT II. An overvoltage category of CAT II means that the equipment is designed to cope
with transient voltages above the rated supply that would be experienced by any product
Rated Pollution Pollution Degree 2. Normally only non-conductive pollution occurs. Occasionally, however, a
Mains Input
Cable pin-outs
Newton CCD, EMCCD and SY: 2.7 kg [5 lb 15 oz]
Newton SO: 4.9 kg [10 lb 12 oz]
Power Supply = 0.65 kg [1 lb 4 oz]
See Appendix B
Indoor use only
0°C to 30 °C ambient
-25°C to 50 °C
<70% (non-condensing)
connected to a mains socket in a building.
temporary conductivity caused by condensation must be expected.
100 mm minimum
90 mm
100-240 V AC 50/60 Hz
(see Section 2.3)
48 W max
IP20
38