D Isconnecting The C Oolant H Oses; 3.10 Installing Software And Usb Drivers; M Inimum C Omputer R Equirements; Nstalling S Olis S Oftware And Usb D Rivers - Oxford Instruments ANDOR Newton CCD Hardware Manual

Newton
3.9.2 d
isconnecting tHe
Notes:
• Push-fit, barbed fittings are not intended for repeated disconnection/connection.
• Fittings are sealed during production and should not be removed from the camera body.
1. Apply pressure and remove the tubing with a twisting motion, while holding the camera body.
2. Once disconnected, the tubing should be inspected for cracks or stretching. It may be necessary to cut the end
section of tubing so that a tight seal can be obtained.

3.10 INSTALLING SOFTWARE AND USB DRIVERS

3.10.1 M c
iniMUM oMpUteR
• 3.0 GHz single core or 2.4 GHz dual or quad core processor
• 2 GB RAM
• 100 MB free hard disc to install software
• Windows (7, 8, 8.1 and 10) or Linux
3.10.2 i
nstalling
1. Terminate & exit any applications which are running on the PC.
2. Insert the Andor Solis CD. The InstallShield Wizard should now start. If it does not start automatically, run the
file setup.exe directly from the CD.
3. Select appropriate location for installation of software and drivers on your computer / network.
4. When prompted, select Newton.
5. Continue installation and restart your computer - when prompted - to successfully complete the installation.
6. The shortcut icon for Solis will appear on the desktop on re-start.
7. The Newton is now ready to be connected to a PC / laptop and powered on.
3.10.3 n H
eW aRdWaRe
When the Newton camera is connected to a PC for the first time, the New Hardware Wizard screen will appear.
1. Select the 'No, not this time only' option then click Next>.
2. Select the 'Install from a list or specified location (Advanced) option then click Next>.
3. Navigate to the directory where the Andor Solis software was installed to on the PC, then click Next> so that
the Installation Wizard can start.
4. Click the Finish button to complete the installation.
Note: If the camera is connected to a different USB port, steps 1 – 4 will have to be repeated on the first
connection only.
5. A system message will appear to indicate that the device has been successfully installed.
Note: You can check that the Newton is correctly recognized and installed by opening the Device Manager (Devices
and printers) in Windows, Control Panel. The Newton will show under the Devices list.
Version 1.4 rev 13 Oct 2017
c H
oolant
R
eqUiReMents
s s
olis oftWaRe and
W
izaRd
oses
Usb d
RiveRs
21