Installing A Usb 2.0 Card (If Not Present) - Oxford Instruments ANDOR Newton CCD Hardware Manual

Newton
3.11 i
nstalling a
USB 2.0 slots (USB 3 is backwards compatible) are found on most PCs. If a USB card needs to be installed please refer
to the guidelines below and instructions supplied with your Card/PC.
Ensure your PC is powered off. Ensure anti-static precautions using anti-static strap provided. Keep all
screws safe.
1. Unplug all cables from the rear of the computer.
2. Open the PC enclosure to gain access to the expansion slots.
Locate a suitable PCIe slot for a USB 2.0 cards:
3.
4. If you are unsure which slot is correct, please consult the PC user manual.
5. Remove the filler bracket corresponding to the slot you intend to use.
6. Remove the PCIe card carefully from its protective ESD packaging and insert the card connector fully into the
expansion slot.
7. Ensure the card's mounting bracket is flush with any other mounting or filler brackets to either side of it, then
secure the controller card in place.
8. Fit the computer panels and any accessories that you were using previously.
Version 1.4 rev 13 Oct 2017
Usb 2.0 c (
aRd if not pResent
)
22