Qtx LED TWISTER IV User Manual

Introduction
Thank you for choosing the LED TWISTER IV light effect as part of your stage effects setup. This machine is easy to set up and
delivers a wide area colourful light effect from a compact housing. Please read and keep this manual to ensure maximum performance
and avoid damage through misuse.
Unpacking
Your LED TWISTER IV should reach you in good condition and should be supplied with IEC mains lead(s) and wired & wireless remote
controls. If there are any signs of damage or items missing from the packaging, contact your dealer.
Warning
To prevent risk of fire or electric shock, do not expose electrical parts to rain or moisture.
If liquids are spilled on the housing or through the vents, disconnect the mains, allow the LED TWISTER IV to dry out and have it
checked by qualified personnel before further use.
Avoid any impact, dropping or extreme pressure to the housing.
No user serviceable parts inside - do not open the case. Refer all servicing to qualified service personnel.
Placement
The LED TWISTER IV is designed to be mounted using the included bracket, which may be adjusted to aim the effect at the target
area. Ensure that the fixing is secure and add a safety wire if mounting at height.
Safety
•
Check for correct mains voltage and condition of IEC lead before connecting to power outlet
• This unit must be earthed
Cleaning
• Use a soft dry or slightly damp cloth to clean the casing
• Do not use strong solvents for cleaning the unit
• Empty contents and rinse the bubble fluid tanks after each use
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
LED TWISTER IV
Light Effect
Item ref: 152.628UK
User Manual