Returning To A Pre-Marked Position - Canon Vistura User Manual

Returning to a Pre-Marked Position

Use the wireless controller to go back to a pre-determined point on a tape
following playback.
1. Press the ZERO SET MEMORY button during playback at a point
you want to return to later.
• The time code is replaced by a tape counter that is set to zero with the
indication.
2. When you have finished playback, fast forward or rewind the tape.
The tape stops automatically when it reaches the zero set position.
• The tape counter with
time code reappears.
Notes:
• Press the ZERO SET MEMORY button once more to cancel the zero set
memory before you forward/rewind the tape.
• The zero set memory may not function correctly where there is a break between
recordings on the tape.
• You can also use zero set memory to mark a position on a tape in record pause
mode. When you then play back the tape, pressing rewind will take you back to
the pre-marked position.
• If you remove the tape while the zero set memory is set, the memory is
canceled and the tape counter reverts to timecode.
P
POWER
OFF
VCR
indication disappears from the display and the
M
E
DATA
EXECUTE
CODE
ZERO SET SEARCH
MEMORY SELECT
REC
PAUSE
REW PLAY FF
STOP
PAUSE SLOW 2
M
57