Canon Vistura User Manual page 22

Connecting the RF unit/adapter cables
1. Connect the RF unit to the camera, using the RC-150 RF adapter
cables.
• The RF unit and RF adapter cables are available separately.
2. Connect the antenna cable to the FROM ANT. terminal on the RF
unit.
• If your TV has flat twin-lead cable, use the 300–75 ohm adapter.
3. Connect the TO TV terminal on the RF unit to the antenna input
on the TV.
• Use the coaxial cable with F-connectors.
If your TV has flat twin-lead cable, use the 75–300 ohm adapter.
Attaching the 300–75 ohm adapter
Loosen the screws on the adapter and insert the antenna
cable. Tighten the screws again.
If the antenna cable does not have antenna lugs, you will
need to strip one end of the cable and wind the wires around
the screws.
Selecting the video channel
Turn the TV on, start playback on the
camera (see p. 18), and set the TV and
the RF unit to the video channel.
The video channel is the channel which
is not used by a broadcasting station in
your area and can be used for
videocassette playback (channel 3 or 4).
Note:
• Turn the camera off or disconnect it from the RF unit when you want to watch a
broadcast program.
4CH 3CH
TO TV FROM ANT
4CH 3CH
E
23