Setting Parameters At The Pyrometer (Basic Configuration) - Keller ITS CellaCast PT 18 Series Operating Manual

Operating Manual PT 18x
7 Setting parameters at the pyrometer (basic configura-
tion)
Use the buttons ▲▼ and the „MODE" button on the rear panel to access
and configure parameters. With these buttons you can view and adjust
all settings required for operating the pyrometer.
Hierarchy of manual configuration:
MOD
E
Normal
operating mode
(temperature
measurement)
1. Press the MODE button while in normal operating mode to switch
to "configuration layer" mode.
2. Use ▲▼ to select the configuration layer for the parameter you
wish to set.
3. Press MODE to confirm. Press ▲▼ to select the particular param-
eter.
4. Press MODE to confirm. Press ▲▼ to adjust the parameter value.
5. Press MODE again to end. Press ▲▼ to select
Whenever a control key has not been pressed within 30 seconds, the py-
rometer will automatically return to normal operating mode.

Key lock may have been activated at the terminal. When select-
ing the configuration layer you will be prompted to enter an ac-
cess code with
tings, enter
rameters but not change them.
MOD
E
Select
config. layer
C000-
C999
▲▼
P000
. To obtain full access to parameter set-
P100
otherwise you will only be able to view pa-
10
MOD
E
Select
parameter
EPS
▲▼
END
Adjust
parameter
99.9
▲▼
.