Notifier ID50 Operating Manual page 55

ID50 Series Panel - Operating Manual
VIEW sensors remain
TM
inoperable for 60 seconds
after being replaced
while calibrating
Appendix 3
ID60 Single Loop Panel Differences
The ID60 Panel differs from the ID50 Panel in that it
supports Very Intelligent Early Warning (VIEW
This appendix describes differences to the user
operations required by the ID60 Panel.
Each VIEW sensor has to be calibrated on first
TM
operation with the panel. If a VIEW
and cleaned, or replaced with a new one, wait at least
30 secs after removal before replacing it.
Calibration is carried out automatically for each sensor
approximately 60 secs after the sensor is installed on a
panel which is already operating normally.
During this initial period (which is required to allow the
VIEW sensor to stabilise) the sensor must not be
TM
exposed to smoke or any other abnormal conditions,
otherwise the panel may report a sensor fault.
A3 - 1
) sensors.
TM
sensor is removed
TM
997-264, Issue 4
September 2002