Notifier ID50 Operating Manual page 35

[U0 Disable/Enable]
3
Start Day Mode
Press 3to confirm
ID50 Series Panel - Operating Manual
4.9.3 Day Mode - User Option
If Day Mode is enabled during panel commissioning, this
option allows the user to activate/deactivate Day Mode
delays during the set Day Mode time period. This has no
effect on any sensor sensitivity changes that may have
been configured during commissioning. Any sensor
sensitivity changes will automatically occur at the set Day
Mode period start and end times.
To Disable / Enable Day Mode, proceed as follows:
1:Zone
3:Day Mode 4:Delays
1 From the Disable / Enable menu, press the ‘
2 Press the ‘
5
[U0 Disable/Enable] 1:Zone
3:Day Mode
3 To end Day Mode, repeat steps 1 and 2 (the display is
End Day Mode
Press 3to confirm
Note: If Day Mode is NOT cancelled manually, Day Mode
29
2:Outputs
to display the following:
<:Cancel
’ button to confirm the requested
5
operation. The LCD automatically returns to the
Disable / Enable menu.
If Delays have been configured the DISABLEMENT
and DELAYED MODE LEDs illuminate when Day
Mode is started.
2:Outputs
4:Delays
as shown below):
The DELAYED MODE LED will extinguish when the
Day Mode operation has been ended, either when day
mode is turned off or when the timer has timed out.
No delays are active. The DISABLEMENT LED will
extinguish provided there are no other disablements
present.
delays are automatically deactivated at the end of
the set time period.
’ button
3
<:Cancel
997-264, Issue 4
September 2002