Fitting The Controller Into Alternative Cabinets - Siemens ST950 Handbook

6 F T
ITTING
The controller rack may be fitted into enclosures other than the single sided ST950
cabinet. In the UK the alternative cabinet must be one that has previously been
approved to house a different controller. Some examples are Siemens T200,
T400L, GEC3000, GEC25, GEC CX cabinets and all Microsense and Monitron
cabinets.
The procedure for each type of controller depends largely on the type and condition
of the existing equipment. For this reason it is not possible to define in detail exactly
what needs to be done.
In a T400 or T200 large outercase, access to the rear connectors is available
through the rear door. The cards are held in the rack by a retaining strip at their
front edge. To release it, loosen the clamping screws and allow it to fall clear of the
card guides.
Detailed installation instructions are included in the drawings contained in
the kit relevant to the cabinet.
For some cabinets additional kits of parts are available. These provide brackets and
other equipment that may be helpful during the installation. The kits are listed on
667/DZ/46950/000 and contain the necessary installation instructions.
The standard controller items are used with these kits and are listed in the ST950
Family Tree (667/DZ/46950/000). Refer to Siemens Poole for the latest copy.
Security classification
Version
Last Editor
Document Name
Copyright © Siemens Mobility Limited 2018. All Rights Reserved.
C
HE ONTROLLER
Unrestricted
5
Neil Atkinson
ST950 ICM Handbook
Sopers Lane, Poole, Dorset, BH17 7ER
I A
NTO LTERNATIVE
Page
Status
Date
Document No.
Intelligent Traffic Systems
C
ABINETS
58 of 125
Issued
18-Dec-2018
667/HE/46950/000