Related Manuals for 2VV BASIC VCB-A-060-E-RF-0-0
Summary of Contents for 2VV BASIC VCB-A-060-E-RF-0-0
- Page 1 BASIC EN 3 DE 11 PYC 19 VCB-A-060-E-RF-0-0 VCB-A-090-E-RF-0-0 P01-0103-0813-01...
- Page 3 BASIC VCB-A-060-E-RF-0-0 VCB-A-090-E-RF-0-0...
-
Page 4: Before You Begin
EC Declaration of conformity were applied in the assessment of this product. You will find cur- rent and full version of the EC Declaration of conformity on the www.2VV.cz website. This manual contains important instructions and safety notices. To ensure the correct operation and your own safety it is impor- tant to carefully read the following regulations before using the door heater and to adhere to them! Any kinds of modifications or adjustments made to the internal wiring are forbidden and will result in the warranty becoming void. -
Page 5: Operating Conditions
2. UNPACKING 2.1 CHECK THE DELIVERY DO NOT OVERLOOK Check immediately after delivery that the packed product has not been damaged. If the packaging is damaged inform the carrier. If the complaint is not lodged in time, no future demands can be claimed. After unpacking from the box, check whether: 1. -
Page 6: Rules For Installation
6. INSTALLATION 6.1 RULES FOR INSTALLATION DO NOT OVERLOOK Minimum dimensions must be adhere to as shown in the • picture. If you install the heater above a door, then try to locate it • min. 50 mm as close as possible to the top edge of the door. Make sure that the exhaust of the heater is not shielded by anything min. -
Page 7: Control Panel
6. INSTALLATION 6 2 ELECTRICAL WIRING CONNECTION DO NOT OVERLOOK The heater is connected using a cable with a power plug, which is a part of the unit. • The electric power supply (power socket) into which the heater is connected must be protected by a circuit breaker of at least 16A. •... -
Page 8: Switching On For The First Time
7. SWITCHING ON FOR THE FIRST TIME DO NOT OVERLOOK Before starting the air curtain with an RF control module, check the following: Did you leave any tools or items inside the curtain which could damage it? • There a corresponding el. power supply available including sufficient protection. •... -
Page 9: Maintenance
8. CONTROLS Clearing (un-pairing): This mode is active 30 seconds after power ON of unit (when there was no power supply before). Press buttons simultaneously at least of 4 seconds. If unit will blinking with fan 1 and fan 2 speed simultaneously, then clearing was succesfull. - Page 10 10.1 IF YOU CANNOT FIX THE PROBLEM YOURSELF If you were unable to fix the problem, contact the supplier or an exclusive 2VV distributor. The warranty and post-warranty service is carried out by the supplier or one of the authorised service organisations, their list is available at the supplier.
Need help?
Do you have a question about the BASIC VCB-A-060-E-RF-0-0 and is the answer not in the manual?
Questions and answers