Embraer EMB145 Operation Manual page 256

NORMAL PROCEDURES
MISSED APPROACH
Go Around Button ......................................................... PRESS
Press the Go Around buttons at the thrust levers and check if Flight
Director goes to pitch 10° nose up. Rotate or verify that autopilot
rotates the airplane following the Flight Director.
Thrust Levers ................................................................ MAX
Advance the thrust levers to MAX position and verify the engines
parameter.
Flaps ............................................................................. 9°
Select the flaps control to 9° position.
With positive rate of climb:
Landing Gear ........................................................... UP
Select the landing gear lever to the up position.
Minimum Airspeed ................................................... APPROACH
Maintain the pitch as commanded by the Flight Director or pitch
10° if Go Around is being performed on raw data to maintain the
airplane airspeed above the minimum airspeed (approach climb
speed selected on the MFD).
Once the acceleration height is reached check that the speed is
consistent with the flap retraction speed, reduces the thrust levers to
Thrust Set position. Select flap controls to zero position and select
Climb Mode at the Thrust Rating panel.
NOTE: - For coupled Go-Around the altitude loss may be 75 ft.
- During the GO-AROUND procedure, the DON'T SINK aural
warning may sound. In this case monitor the sink rate and
follow the GO-AROUND guidance.
Page
4
1-02-57
AIRPLANE
OPERATIONS
MANUAL
Code
02
CLIMB SPEED
REVISION 36