USING THE
ULTRA MEASURE MASTER
ENTERING DIMENSIONS AND UNITS
When entering Feet-Inch dimensional val-
ues, you must enter the largest dimension
first — Feet before Inches, Inches before
fractions. To enter fractions of an Inch,
enter the numerator (value above the line),
press / (Fraction Bar key) and then enter
the denominator (value below the line).
numerator
fraction bar
denominator
For all other units of measurement, you
can only enter whole numbers or decimal
numbers. You cannot enter combinations
of units (for example, you cannot enter 12
Meters 6 Centimeters 4 Millimeters).
P
R
OCKET
EFERENCE
3
—
16
G
UIDE
— 19