Machine Function Description - Ispring RO500 Installation Instructions & Owner's Manual

5) Machine Function Description

No. Function
Rinsing Rinse RO MEMBRANE for 5 minutes,
1 Prior to the then flush by running water for 30+
First Use minutes.
Rinsing When the machine is powered on, rinse
After RO MEMBRANE for 20 seconds. If the
2
Powering user turns on the water during the rinsing,
On the system will switch to its normal mode.
If the RO pump accumulates water for
Rinsing
more than 2 hours, rinse the RO
After
3 MEMBRANE for 20 seconds. If the user
Cumulative
runs water during the rinsing, the system
Use
will switch to its normal mode.
If not used after 24 hours, rinse the RO
Self- MEMBRANE for 20 seconds. If the user
4 Cleaning runs water during the rinsing, the system
Rinsing will switch to its normal mode. (Note:
Timer will reset after powering off.)
After replacing each filter:
1.
rinse the filter for 30 minutes.
2.
the RO membrane for 5 minutes.
3.
rinse the filter for 15 minutes.
4.
Rinsing
simultaneously with the other filters:
5 after Filter
Change manual rinse the RO membrane for 5
minutes, then open the faucet to rinse
the filter for 30 minutes.
5.
carbon filter are simultaneously reset:
manual rinse the RO membrane for 5
minutes, then open the faucet to rinse
the filter for 15 minutes.
Running
6 Normal operation.
Water
The machine stops operation and enters
7 Standby
standby mode.
While powering on, multiple display
indicators are on at the same time. Each
Powering indicator flashes in the order of status
8
On (blue, purple, red), and each state is
illuminated for 1 second, for a total of 3
seconds.
Page 15 www.123filter.com
Operation
Compound filter: open the faucet to
RO membrane filter: manual rinse
Post-carbon filter: open the faucet to
RO membrane filter is reset
If the composite filter and the post-
| (678) 261-7611 |
Status Indicator
1. The water quality indicator is
red and flashes once per second.
2. The water quality indicator
shows the real-time data within 6-
35 minutes of water discharge
time and flashes once per second.
The water quality indicator shows
the status before powering off
during the rinsing and flashes
once per second.
The water quality indicator
displays the state prior to flushing
and flashes once per second.
During the rinse, the water quality
indicator displays the quality
before rinsing and flashes once
per second.
1. When rinsing RO
MEMBRANE, the water quality
indicator is lit red and flashes
once per second.
2. The rinsing filter water quality
indicator shows real-time water
quality data and flashes once per
second.
While running, the water quality
indicator displays the water
quality status and is always on.
After 30 seconds, the water
quality indicator displays the real-
time water quality data and is
always on.
Water quality indicator off.
support@123filter.com