Rowenta AQUA PERFECT HU522 Series Manual page 22

EN
The humidification
capacity is too low
The ambient humidity
is too high
There is condensation
in the room
The appliance is too
noisy
The mist suddenly
stops coming out
The warm mist func-
tion doesn't produce
any warm humidity
The appliance does
not work with no
display on screen
There is abnormal
smell mist
Mist fog is coming out
from around nozzle
There is natural or artificial air
replacement in the room which
interfere the increase of HR%.
The air inlet grids and nozzle
could be blocked.
There is too much scale in the
water basin or on the piezo
part.
The Humidity selected rate is
too low.
The appliance is working in
CONTINUOUS MODE.
The humidity target is too high. Select a lower RH% target.
The room temperature is too
low.
The appliance is unstable.
There may be resonance in
water tank due to low water
level.
Programmed timer period has
run out.
The water level indicator is
blinking.
The target humidity level is
reached.
The product is in warm-up
phase.
The mist is too fine to feel the
warmth.
The room temperature is too
cold and the mist may cool
down too quickly.
There is no power supply.
It's first use of appliance.
The water used is dirty or has
rested too long in water tank or
water base.
There are apertures between
the nozzle, the cover and the
water tank.
Check if doors and windows are closed.
Check if there is no air conditioning
working in the room.
Remove any blocking items from the
grids and the nozzle.
Clean the water base according to Main-
tenance Instructions.
Increase Vaporization Speed in CON-
TROL MODE.
Increase Humidity setting in CONTROL
MODE.
Change the mode.
Heat the room up.
Place the appliance on a flat and stable
surface.
Refill the water tank.
Turn your product on.
Refill the water tank.
Wait a few minutes till the end of the
phase.
Increase the speed level.
Increase the speed level and Heat the
room up.
Plug in power plug in main sockets.
The smell will disappear after several mi-
nutes of use.
Clean the water tank and the water base
according to the Maintenance Instruc-
tions.
Reposition the cover and check if the
nozzle is well plugged in the cover.
22