Table Of Contents; General Information; Safety Information - Philips FW-V28 Manual

All manuals and user guides at all-guides.com
CONTENTS
General Information ................. 5
Safety Information .................... 5
Preparation .......................... 6 - 7
Controls ............................... 8 - 10
Operating The System .... 10 - 12
CD - VCD ........................... 12 - 16
Tuner .................................. 17 - 18
Karaoke ..................................... 18
Tape ................................... 19 - 20
AUX ............................................ 20
Recording ......................... 21 - 22
Clock ......................................... 22
Timer .......................................... 23
Specifications ......................... 24
Maintenance ............................ 25
Troubleshooting .............. 25 - 26
Untitled-1 5

GENERAL INFORMATION

Accessories
IMPORTANT:
PLEASE NOTE THAT THE
- Remote control
VOLTAGE SELECTOR
- Batteries (two AA size) for remote
LOCATED AT THE REAR OF
control
THIS SYSTEM IS PRESET AT
- AM loop antenna
220V FROM THE FACTORY.
- FM wire antenna
FOR COUNTRIES THAT
- AC power cord
OPERATE AT 110V, PLEASE
- One Video cinch cable
ADJUST TO 110V BEFORE YOU
SWITCH ON THE SYSTEM.

Safety Information

• Before operating the system, check that
General Information
the operating voltage indicated on the
• The type plate (which contains the
typeplate (or the voltage indication
serial number) is located at the rear
beside the voltage selector) of your
of the system.
system is identical with the voltage of
• Recording is permissible if your local power supply. If not, please
copyright or other rights of third consult your dealer. The typeplate is
parties are not infringed. located at the rear of your system.
• When the system is switched on, do not
move it around.
Environmental Information
• Place the system on a solid base (e.g. a
All unnecessary packaging has been
cabinet).
omitted. We have tried to make the
• Place the system in a location with
packaging easy to separate into three
adequate ventilation to prevent internal
materials: cardboard (box), polystyrene
heat build-up in your system.
foam (buffer) and polyethylene (bags,
Allow at least 10 cm clearance from the
protective foam sheet).
rear and the top of the unit and 5 cm
Your system consists of materials which from each side.
can be recycled and reused if disassembled
• Do not expose the system to excessive
by a specialized company. Please observe
moisture, rain, sand or heat sources.
the local regulations regarding the disposal
of packaging materials, exhausted
batteries and old equipment.
SAFETY INFORMATION
• Under no circumstances should you
(Supplied)
repair the system yourself, as this will
invalidate the warranty!
• If the system is brought directly from a
cold to a warm location, or is placed in a
very damp room, moisture may
condense on the lens of the disc unit
inside the system. Should this occur, the
disc player will not operate normally.
Leave the power on for about one hour
with no disc in the system until normal
playback is possible.
• Electrostatic discharge may cause
unexpected problems. See whether
these problems disappear if you unplug
the AC power cord and plug it in again
after a few seconds.
• To disconnect the system from the
power supply completely, remove
the AC power plug from the wall
socket.
31/05/2001, 11:35 AM
5
3139 116 20021