Table of Contents
Advertisement
Servo...
Option upgrade –
Installation procedure
• Set the On/Off switch to Off.
• Insert the Option card.
• Set the On/Off switch to On. The installation
window will now appear on the screen and the
semi-automatic installation procedure will start.
Follow instructions given on the screen.
• Press the Main Rotary Dial to start the upgrade (or
switch the system Off to cancel).
• The installation program will now check the
versions of the system software and hardware
installed in the Servo.... This check is done to detect :
– If a new system software installation is required
prior to the option upgrade
and/or
– If the upgrade must be terminated due to
hardware incompatibility (see Note 1 below).
• If detected that a system software update is
required, this installation will start. The installation
may take up to 15 minutes.
• When the system software update is completed (or
found not required), press the Main Rotary Dial to
restart the Servo... as instructed on the screen.
Do not remove the Option card.
• The option upgrade will now start. This installation
of the new configuration will take only a few
seconds. Information on the screen will state if the
upgrade was successful (see Note 2 below).
• Remove the Option card and close the slot cover.
• Restart the system with the On/Off switch.
• Perform a "Pre-use check" according to instructions
in the new Servo... Ventilator System – User's
manual.
• Hand-over the new User's manual to the customer.
Make sure that the old User's manual is deleted.
Note 1:
If detected by the installation program that the
update/upgrade cannot be installed due to hardware
incompatibility, the installation will be terminated.
A message will occur on the screen. Remove the
PC card and restart the Servo....
E382 E407E 061 01 01 02
System software update –
Installation procedure
• Set the On/Off switch to Off.
• Insert the S/W version update card.
• Set the On/Off switch to On. The installation
window will now appear on the screen and the
semi-automatic installation procedure will start.
Follow instructions given on the screen.
• Press the Main Rotary Dial to start the update (or
switch the system Off to cancel).
• The installation program will now check the
versions of the system software and hardware
installed in the Servo.... This check is done to detect:
– If a new system software installation is required
and/or
– If the update must be terminated due to
hardware incompatibility (see Note 1 below).
• If a system software update is required, this
installation will start. The installation may take up to
15 minutes. However, if an update is not required,
the installation is terminated. A message will occur
on the screen.
• When the installation is completed (or found not
required), press the Main Rotary Dial to restart the
Servo... as instructed on the screen. Do not remove
the S/W version update card.
• The system will start-up in standby mode. Remove
the S/W version update card and close the slot
cover when the "Do you want to start Pre-use
check?"-window appears on the screen.
• Perform a "Pre-use check" according to
instructions in the Servo... Ventilator System – User's
manual.
Note 2:
The option upgrade is possible only if the new
configuration on the Option card matches the serial
number of the Servo.... If not, the option upgrade will
not be installed and the system will start-up in
standby mode. Remove the Option card when the
"Do you want to start Pre-use check?" -window
appears on the screen.
Such installation is equal to a system software
update.
Siemens-Elema AB
Service procedures
5
5 - 3
Advertisement
Table of Contents
