Care And Maintenance - pro.point 8630972 User Manual

V1.0
NOTE: If the impact wrench does not tighten the fastener to
your satisfaction, do not raise the air pressure on the
compressor over 90 PSI. Pressure above 90 PSI will strip the
work piece and damage the tool, potentially causing tool
failure and serious injury. Use other appropriate methods and
tools to tighten the nut.
4. When the fastener is tightened, release the trigger and
remove the tool and socket.
5. Use a mechanical torque wrench to check the
fastener torque.
6. When finished with the tool, turn off the air compressor,
disconnect the air hose and discharge any residual air
remaining in the tool. Put the butterfly air impact wrench
away in a storage area.
CARE & MAINTENANCE
WARNING! Disconnect the tool from the air supply before
changing accessories, servicing or performing maintenance.
1. Maintain the tool with care. A tool in good condition is
efficient, easier to control and will have fewer problems.
2. Inspect the tool fittings, alignment, hoses and power supply
cord periodically. Have damaged or worn components
repaired or replaced by an authorized technician. Only use
identical replacement parts when servicing.
3. Follow instructions for lubricating and changing accessories.
4. Only use accessories intended for use with this tool.
5. Keep the tool handles clean, dry and free from oil/grease at
all times.
Visit www.princessauto.com for more information
1/2 in. dr. Micro Stubby Air Impact Wrench 8630972
11