Assembly And Installation - pro.point 8630972 User Manual

V1.0
UNPACKING
WARNING! Do not operate the tool if any part is missing.
Replace the missing part before operating. Failure to do so
could result in a malfunction and personal injury.
Remove the parts and accessories from the packaging and
inspect for damage. Make sure that all items in the parts list
are included.
ASSEMBLY & INSTALLATION
INSTALLING AIR QUICK COUPLER
Prepare a standard 1/4 in. NPT male air quick coupler for use
with your tool.
1. Remove the plastic cap from the air inlet.
2. Wrap the external threads of the male quick coupler with
sealant tape.
a. Wrap the tape in a clockwise direction so it will
not unravel.
b. Do not tape all the threads. Leave several leading
threads unwrapped for easier alignment.
3. Screw the quick coupler into the tool's air inlet and tighten
with a wrench until snug.
4. Run the compressor at a low volume and check the
connection for air leaks. Do not use the tool until all air
leaks are repaired or the faulty component is replaced.
NOTE: Vibration may cause failure if a quick coupler is
connected directly to the air drill. To overcome this, connect a
leader hose to the tool. A quick coupler may then be used to
connect the leader hose to the air line hose.
Visit www.princessauto.com for more information
1/2 in. dr. Micro Stubby Air Impact Wrench 8630972
9