Gavita Pro 1000e Manual

Gavita Pro 1000e Manual

380-400v
Hide thumbs Also See for Pro 1000e:

Advertisement

Pro
line
Gavita
Pro 1000e 380-400V
1
Introduction
Thank you for purchasing the Gavita Pro 1000e 380-400V DE EU. This manual describes the mounting and installing of the
product and also describes how to use the product. Please read and understand this manual completely before using the
product. Only use the product as specified in this manual.
1.1
Used Symbols
Warning! A warning indicates severe damage to the user and/or product may occur when a procedure is not carried
out as described.
Caution! A caution sign indicates problems may occur if a procedure is not carried out as described. It may also
serve as a reminder to the user.
Note: A note gives additional information, e.g. for a procedure.
This symbol indicates that the reflector and lamp can reach very high temperatures (>85 °Celsius). Observe a cool
down period before performing maintenance.
With this symbol Gavita declares that this product complies with European requirements.
The symbol on the material, accessories or packaging indicates that this product may not be discarded as
household waste. By disposing of the equipment in the proper way, you will be helping to prevent possible risks
to the environment and public health, which might otherwise be caused by improper handling of the discarded
equipment. Recycling of materials contributes tot the conservation of natural resources. Therefore, please do not
dispose of your old electronics and electrical appliances via household waste.
This symbol indicates the minimum distance (B) between the luminaire (A) and the lit surface.
A
B
2
Product description
The Gavita Pro 1000e 380-400V DE EU is an adjustable horticultural luminaire. The Gavita Pro 1000e 380-400V DE EU can
be used to drive a double ended 380-400V high frequency (electronic) high pressure sodium lamp.
The Gavita Pro 1000e 380-400V DE EU is an e-series product. It can be remotely switched and adjusted by a Gavita Master
controller. The controller can automatically switch the luminaire on and off during a 24 hour cycle.
The controller also offers a temperature safety feature: auto-dimming or switching off connected luminaires when the
temperature in a climate room becomes too high.
The product can also be controlled by conventional timers in combination with a contactor. Make sure the dummy RJ plug
sits in the IN port. If not, the luminaire will not operate.
In this manual, the Gavita Pro 1000e 380-400V DE EU will be referred to as: "the luminaire".
1

Advertisement

Table of Contents
loading

Summary of Contents for Gavita Pro 1000e

  • Page 1 380-400V high frequency (electronic) high pressure sodium lamp. The Gavita Pro 1000e 380-400V DE EU is an e-series product. It can be remotely switched and adjusted by a Gavita Master controller. The controller can automatically switch the luminaire on and off during a 24 hour cycle.
  • Page 2: Product Information And Specifications

    Product information and specifications General product information Product name Gavita Pro 1000e 380-400V DE EU Manufacturer Gavita International BV Version HR96 W150 EAN Code 8718692232594 8718692232617 Part number HGC906201 HGC906301 Technical specifications Version Gavita Pro 1000e 380-400V DE EU Product weight 3.8 kg...
  • Page 3: Safety Recommendations And Warnings

    • Do not use the luminaire when either its lamp or its power cord are damaged. Replace the power cord only with original certified cords. Replace the lamp only with lamps specified by Gavita (see paragraph 3.3). • The use of other lamps may damage the product and lamp and will void the warranty.
  • Page 4 Damage to the luminaire and electronic circuitry as a result of incorrect installation and use revokes the warrant. Contents (1) A. Gavita Pro 1000e 380-400V DE EU 1. Electronic ballast 2. Lamp bracket 3.
  • Page 5: Installation

    The repeater bus connection kit contains the following items: 2 x EMC ferrite snap-on black bag (13x12x5x25.5x2.4) 4 x Gavita splitter 1 to 2 6P6C grey RJ25 (in bag) 8 x grey modular jack interconnect cable 6P6C RJ25 (in bag)
  • Page 6 line line Preparation for use with a controller Using a daisy chain setup, a maximum of 100 luminaires can be connected to one controller. Up to 500 luminaires per daisy chain can be connected when using splitters. See section 7.5 and 7.6 of this manual and the manual of the controller. 1.
  • Page 7 line line 4. Use a grey 6PC6 modular jack interconnect cable (item C) to connect the output port of the first luminaire to the input port of the second (11D). 5. Repeat these steps to connect up to 100 luminaires per splitter output port (11E). Up to 500 luminaires can be connected to the primary channel.
  • Page 8 line line Connecting the luminaire to the mains Warning! Make sure mains power is switched off. Warning! Always install the lamp before connecting the luminaire to the mains. Warning! Ensure the cord is not coiled and does not touch any hot surfaces. Warning! Connect the cables according to local rules, safety regulations and electrical code.
  • Page 9: Product Use

    line line Product use Warning! Never use the luminaire without a lamp or reflector! Warning! Always wait 20 - 30 minutes for the reflector to cool down! Caution! Before you dim or boost your HPS lamp, make sure that you run it at nominal value (100%) for at least 100 hours to stabilize the lamp.
  • Page 10: Inspection, Maintenance And Repair

    Caution! Do not touch the inside of the reflector during installation and do not use water, abrasives or detergents to clean it. This will damage the reflective surface. Note: Gavita recommends to measure the lamp and reflector for aging every year. Replace the lamp and/or reflector when they are aged.
  • Page 11 Caution! Do not touch the lamp with bare hands as this will damage the lamp. Always use a fabric glove to handle the lamp. Caution! Only use lamps specified by Gavita (see paragraph 3.3). Note: The lamp must be replaced every year or after 5000 lighting hours, whichever one comes first.
  • Page 12 Warning! Always allow for a cool down period of at least 30 minutes before touching the lamp or reflector. Note: Gavita recommends replacing the reflector* after 5000 lighting hours. Depending on the environment and contamination levels the reflector will degrade. The Vega Miro™...
  • Page 13: Storage And Disposal

    Gavita International bv shall, at its discretion, either replace or repair the product using suitable new or reconditioned products or parts. For HPS lamps the warranty period is one (1) year from the original date of purchase. In case Gavita International bv decides to replace the entire product, this limited warranty shall apply to the replacement product for the remaining initial warranty period, i.e.
  • Page 16 Gavita International BV T +31(0)297-380 450 Manual: Gavita Pro 1000e 380-400V Naritaweg 8 F +31(0)297-380 451 Changes reserved - Version 21/11 1437 EL Rozenburg NH info@gavita.com Not for sales or use in the Netherlands The Netherlands www.gavita.com...

Table of Contents