Gavita Pro 1000e Manual page 12

Pro Pro line line
10.3 Placement and replacement of the reflector
Warning! Always allow for a cool down period of
6
at least 30 minutes before touching the lamp or
reflector.
Note: Gavita recommends replacing the
2
reflector* after 5000 lighting hours.
Depending on the environment and contamination
levels the reflector will degrade. The Vega Miro™
aluminum can not be cleaned without damage.
Therefore we recommend to change the reflector once
every year. Also replace the lamp when replacing the
reflector.
* The reflector is delivery dependent, it may differ
from the image.
1. Switch off mains power.
2. Remove the lamp from the luminaire (see
paragraph 10.2).
3. Support the reflector on the side of the reflector
lever to prevent it from falling (23).
4. Move the reflector lever up to retract the two pins
holding the reflector in place (24).
5. Remove the reflector (25).
6. Place the new reflector. Ensure the reflector lever
is in the opened position to allow the reflector to
pass.
7. Ensure the holes in the reflector are aligned with
the pins in the fixture (26).
8. Release the reflector lever so its two pins hold
the reflector in place.
9. Insert the lamp in the lamp holder (see
paragraph 10.2).
10. Switch on mains power.
23
24
25
26
12