Gavita Pro 1000e Manual page 11

Pro Pro line line
10.2 Placement and replacement of the lamp
Warning! Always allow for a cool down period of
6
at least 30 minutes before touching the lamp or
reflector.
Caution! Do not touch the lamp with bare hands
1
as this will damage the lamp. Always use a fabric
glove to handle the lamp.
Caution! Only use lamps specified by Gavita (see
1
paragraph 3.3).
Note: The lamp must be replaced every year or
2
after 5000 lighting hours, whichever one comes
first.
1. Switch off mains power.
2. Hold the lamp with a fabric glove to prevent it
from falling. Use a protective glove if the lamp is
damaged.
3. Open the lamp holders by sliding them outwards
(19).
4. Carefully take the lamp out of the luminaire (20).
5. Install the new lamp with the getter near the
ballast (21), with the glass vacuum seal pointed
downwards (Philips lamps) or sideways (Gavita
lamps).
Both lamp wires need to be placed straight into
the lamp holder and need to touch the metal part
of the lamp holder.
6. Close the lamp holders by sliding them inwards
(22).
7. Switch on mains power.
19
20
21
22
11