Gavita Pro 1000e Manual page 8

Pro Pro line line
7.7 Connecting the luminaire to the mains
Warning! Make sure mains power is switched off.
6
Warning! Always install the lamp before connecting the luminaire to the mains.
6
Warning! Ensure the cord is not coiled and does not touch any hot surfaces.
6
Warning! Connect the cables according to local rules, safety regulations and electrical code.
6
Warning! If external switching gear is used to switch the luminaire, ensure it can cope with the inrush current of the
6
luminaire (see paragraph 3.2). Always use a double pole contactor suitable of switching a capacitive load. Never use
household timers to switch the luminaire!
1. Plug the Wieland RST20i3 female connection onto the Wieland RST20i3 male connection on the luminair (12).
2. Switch on mains power.
Warning! Do not connect or disconnect the Wieland RST20i3 plug under load.
6
To install a new power cord:
1. Remove the top part of Wieland RST 20i3 female connector from the bottom part (13).
2. Pull the mains cable through the bottom part (14).
3. Strip the wiring (15).
The insulation strip length is 8 mm and the dismantling length is 32 mm.
4. Connect the wiring to the top part connections (16).
Cable description:
Wire
Blue
Brown
Green/Yellow
5. Slide the top part into the bottom part and tighten the gland nut (17).
Note: When the parts connect correctly, you will hear a 'CLICK' sound.
2
12
32 mm / 1.26"
8 mm / 0.31"
15
380-400V
Phase (L)
Phase (L)
Ground
2 2
13
N/L
1 1
16
1 1
1 1
14
2 2
17
8
CLICK!
1 1
2 2