Menu Items - DCS 900E User Manual

dCS 900E / 902E User Manual
dCS Ltd

Menu Items

Issue
Displays the software
Filt
Selects one of several anti-alias
evaluated by ear.
frequency. This is the normal setting. Filt2, Filt3,
relaxed responses, degrading the alias performance but sharpening the impulse
response. This affects the stereo or multi-channel image. Different filters may
be appropriate for different material.
DSD
DSD 4
DSD
they are permanently set to Off.
Tone
This accesses a sinewave test generator. On the dCS 900, the tone is fixed at
1kHz and -18dB0. Press
On the dCS 902, the tone level and frequency can be adjusted. Pressing
enters a submenu, which accesses the following functions:
Level
Freq
On/Off
Up
At power up, the tone generator is set to –18dB0, 1kHz and turned Off.
Test
Runs a display self test routine. When successfully completed, the unit displays
Pass
displayed – please refer to
specific information.
7-Seg
Disables the 7 segment LED display. When set to Off, the display turns off 4
seconds after the last button press. A dot in the lower right hand corner of the
display remains lit to indicate that the display has been deliberately blanked.
The display springs back into life (temporarily) if the menu is used subsequently.
Error or warning messages are displayed regardless of this setting.
Manual part no: DOC0029021E1
Contact on + 44 1799 531 999
dCS
(inside the UK replace + 44 with 0)
All manuals and user guides at all-guides.com
-
issue- when
-
Filt1
gives the sharpest cut off, just below half the sampling
-
-
DSD 4
and modes are only available on the dCS 904. In the dCS 900 & 902,
-
Set to toggle it
The tone level, from –120dB0 to 0dB0. It can be
changed in 0.1dB steps using the
buttons.
The tone frequency, from 0.001kHz (1Hz) to just
under half the sample rate. It can be changed
using the
1Hz for tones up to 100Hz, 10Hz up to 1kHz and
100Hz above 1kHz.
Toggles whether the generator is on or off.
Allows the menu to be re-entered to set other
functions. Alternatively, if left, the menu will just
time out keeping the last settings.
-
and returns to normal operation. Otherwise an error message
"Error Codes and Messages"
-
Page 20
Manual for Software Versions 1.3x to 1.5x
Set is pressed.
filter- responses. The filters should be
Filt4
give progressively more
On and Off.
Up
Up and Down buttons. The step size is
Document No: OS-MA-D0002-902.1E1
email to: more@dcsltd.co.uk
web site: www.dcsltd.co.uk
th
12 June 2000
Set
and Down
Err.xy
is
on page 58 for more