A-Sl - DCS 900E User Manual

dCS 900E / 902E User Manual
dCS Ltd
Heat
Displays the internal temperature of the unit. Press
Fahrenheit and Celsius.
Phone
dCS telephone number scrolls across the display
Part
The control board part number (version) scrolls along the display.
S-No
The control board serial number scrolls along the display. You will need to tell us
this number if you call us for help.
RS232
Displays - and allows access to – the unit's RS-232 identity code (an address
between 0 and 99). This is used by the remote control software, to send specific
messages to specific units. Use
operating several units in a multichannel set up. On dCS 900, press (or hold
down) the
IMPORTANT!
Each unit in a daisy chain MUST be set to a different RS-232 address.
BNC O
This feature is available on the dCS 904 only. In the dCS 900 & 902, it is
permanently set to SDIF.
Ref In
Sets the mode of the
are:
Loop
Loop.t
Int

A-SL

Turns Auto-slaving
reference or a word clock in causes the unit to slave and lights the Slave LED.
If both are present, the unit picks the highest priority one (AES/EBU) unless the
Master/Slave
unit does not react when a reference is connected.
IMPORTANT!
Ensure the
AES Reference.
Manual part no: DOC0029021E1
Contact on + 44 1799 531 999
dCS
(inside the UK replace + 44 with 0)
All manuals and user guides at all-guides.com
-
-
-
-
-
Master/Slave button to change this setting.
-
-
AES Reference In
Loops the
output, with no termination resistor (termination is
then about 1kohm, so several units can be daisy
chained).
As above, but terminates the input. Use at the end
of a daisy chain.
The output (and input in parallel – beware!) is
internally driven, with the same signal as
-
On or Off. When set to On, connecting an AES/EBU
button is used to move down the priority list. When set to Off, the
Ref In
menu item is set to
Page 21
Manual for Software Versions 1.3x to 1.5x
Set
Up and Down to change this address if you are
/ AES C Out connectors. The options
Reference In through to the
Loop Loop.t
or before connecting an
Document No: OS-MA-D0002-902.1E1
email to: more@dcsltd.co.uk
web site: www.dcsltd.co.uk
th
12 June 2000
to toggle between
AES C
AES 1.