Yumpu MT08 User Manual page 30

1.3 Flange installation
1.3.1 Put the gasket under the flange and holing, then tighten with screws.
1.3.2 Put sealing ring
1.3.3 The sensor has two circle sealing rings, first fit the bigger ring and then the small one, fix
them on the top of the sensor, see the flow chart.
1.3.4 Screw tighten the sensor
1.3.5 Put the sensor into the flange opening, and screw tighten along the screw thread direction,
then wiring and wrapping.
1.3.6 Power supply of the fuel sensor
The sensor power voltage is 18-32VDC. Note: Do not connect the biggest power line in
the vehicle, please connect the normal size power line, otherwise will burn the sensor.
1.4 Tools required
Tools: Hand-drill, Metal hole saw, Hex tapping screws (3cm)
Pistal Drill
Extension cable of Fuel sensor: it's better wiring along the fuel tank, generally for a big vehicle,
9~10 m cable is enough and 5~8 m for a small vehicle; choose the 3-core, 0.75mm2 cable.
2 Fuel Sensor on the platform applications
2.1 Into our GPS Tracking Platform: http;//www.global-track.net , as following picture P1，
login interface，(as following picture P2)
P1 P2
User Manual of MT08
Hole saw Hexagon self tapping screw
P2
- 30 -