Appendix 3: Fuel Sensor Installation And Function - Yumpu MT08 User Manual

Initialization
To turn all the parameters /
settings (except for
password) to factory default.
Password Initialization

Appendix 3: Fuel Sensor Installation and Function

1. Installation instruction
1.1 Installation flow chart:
1.2 Operation procedures:
1.2.1 Find the position
Generally installed in the middle of the fuel tank, to avoid the original fuel floater
1.2.2 Clean the oil stain on the installation position
Clean the oil stain on the installation position
1.2.3 Holing
Use hand-drill with a 42mm metal drill bit, connect the power supply and drill in the
position (Note: please do not drill too fast, stop when it is about to drop, then use the screwdriver
and sharp-nose plier to remove the attached metal scraps to prevent them dropping into the tank ).
Special note: Make sure to open the fuel tank cap before drilling; it's better to drain away all
diesel, if not, just make sure not too full in the tank.
1.2.4 Cleaning work
Use the grater to polish the rough selvedge;
Use a rope-tied magnet to adsorb the iron scraps.
User Manual of MT08
W******,990,099###
the
W888888,999,666
- 29 -
### is the ending character.
This command will reset the
current password to factory
default password 000000